Fluke Red Test Connector Adapter With Brass contacts and Gold Plated

This test connector adaptor converts a banana jack Interface to a range of small-pin sockets for use in electrical test setups. It is a red insulated adaptor intended for handheld or hands-free measurements where access to crowded multi-socket connectors is required. The connector is CE approved for compatibility with relevant safety expectations and has a voltage limit suitable for dc test applications.

• Gold-plated contacts reduce contact resistance and enhance signal integrity
• Brass contact components provide mechanical durability during use
• Rated for 70V dc to support low-voltage testing workflows
• 3A current capacity enabling higher current continuity checks
• Fully insulated body reduces risk of shorting adjacent contacts
• Flexible tip design permits access to closely spaced pins

• Suitable for probing multi-socket connector sockets in assemblies
• Used with test rigs requiring banana-to-pin transition
• Ideal for continuity and functional checks on wiring harnesses
• Can be used for Rapid fault isolation on dense connectors
• Used for bench testing where adjacent-contact access is needed

The lower pin contacts are gold-plated over nickel and the upper banana body is bright tin-plated.

The operating temperature specified is +55°C maximum.

Yes, variants accept a range of pin diameters corresponding to 22AWG, 20AWG, 16AWG and 12AWG sizes.

For personal safety, do not hold the adaptor in hand when voltages exceed 33Vrms/70Vdc.

The test leads and prods illustrated in this catalogue should NOT be used for testing circuits of more than 50Vac unless specified otherwise. When testing live circuits, under no circumstances should the fuse rating exceed the quoted rating of the test leads.