PR Electronics 3 Series Signal Conditioner, Current Input, Current Output, 6 → 35V dc Supply, ATEX, IECEx

RS-stocknr.:: 136-8709
Fabrikantnummer:: 3186B1
Fabrikant:: PR Electronics

Subtotaal (1 eenheid)*

€ 136,65

(excl. BTW)

€ 165,35

(incl. BTW)

GRATIS bezorging voor bestellingen vanaf € 75,00

Op voorraad

11 stuk(s) klaar voor verzending vanaf een andere locatie

Heeft u meer nodig? Klik op 'Controleer leverdata' voor extra voorraad en levertijden.

Aantal stuks	Per stuk
1 +	€ 136,65

*prijsindicatie

RS-stocknr.:: 136-8709
Fabrikantnummer:: 3186B1
Fabrikant:: PR Electronics

Specificaties

Datasheets

Wetgeving en conformiteit

Productomschrijving

Zoek vergelijkbare producten door een of meer kenmerken te selecteren.

Alles selecteren	Attribuut	Waarde
	Merk	PR Electronics
	Module Type	Signal Isolator
	Input Signal Type	Current
	Output Signal Type	Current
	Supply Voltage	6 → 35V dc
	Hazardous Area Certification	ATEX, IECEx
	Operating Temperature Range	-25 → +70°C
	Series	3
	Minimum Operating Temperature	-25°C
	Maximum Operating Temperature	+70°C

	Alles selecteren
	Merk PR Electronics
	Module Type Signal Isolator
	Input Signal Type Current
	Output Signal Type Current
	Supply Voltage 6 → 35V dc
	Hazardous Area Certification ATEX, IECEx
	Operating Temperature Range -25 → +70°C
	Series 3
	Minimum Operating Temperature -25°C
	Maximum Operating Temperature +70°C

Land van herkomst:: DK

PR Electronics 3186 2-wire Transmitter Isolator

3186 type is a 1 or 2 channel input loop powered isolator. Inputs and outputs are floating and galvanically separated. The converter eliminates ground loops and can be used for measuring floating signals.

Features and Benefits

• High basic 0.05% accuracy in all available signal ranges

• 2.5 kVAC isolation and have excellent noise immunity

• NAMUR NE21 burst A criteria

• Transmits rapid changes in process measurements to PLC/DCS for fast and accurate monitoring of critical signals

• Low temperature coefficient better than 0.01% / °C in a wide -25 to +70°C ambient temperature range for precise measurements

• Long term accuracy better than 0.1% / 3 years with no need for re-calibration

• Installation in ATEX Ex zone 2 / IECEx Zone 2 / FM division 2

DIP-switch programming

Re-calibration is not needed after changing the DIP-switch range settings. Just change the DIP-switch, cycle the power to the unit and obtain the new, pre-calibrated I/O range. HART programming is enabled for selected devices.

Mounting

Devices can be mounted both vertically and horizontally with no air gap separation required. The devices snap onto a power rail or DIN rail and are easily detached by lifting the bottom lock.

High level of isolation

Safe galvanic isolation of 2.5 kVAC provides high noise immunity and prevents ground loops for accurate delivery of the process signal to your control system.

Device status indicators

A front LED indicates device status, e.g. an error in the set-up, sensor or hardware.

Over voltage- / polarity protection

All terminals can withstand up to ±31.2 VDC and are protected against incorrect supply wiring to ensure safe, error-free installation.

PR Electronics DIN Rail Mounting