RS PRO Crimp Tool Crimp Tool for Scotch Terminals

Plier crimp tool with PVC grip handles for great handling and spring return

Jaws manufactured from hardened steel EN9 – gap when closed is 5.0 to 5.5 mm

Ideal for ’Scotchlok’ connectors

Length: 150 mm

Width: 10 mm

Jaw opening: 27 mm

Crimping tools can be used for a variety of applications:-

• Maintenance & repair

• Electrical Installations

• Cable assemblies

• Telecommunications industry

Un-insulated crimp tools are typically used for general applications, whereas the insulated crimp tools have been VDE tested up to 1000 V, designed for use where electrical current is present.

• To maintain a good function and long life: Axles and other movable parts should be regularly lubricated

• Lubrication* is recommended at least every 10,000 cycles whenever the tool is exposed to dirt or other contaminants

• Adjustment of the crimping die nests should also be checked. Readjustment of the pressure adjustment axle is necessary when the pre-load of the tool decreases significantly.

*Use a light mineral-free oil

When a crimping tool is used on a terminal, two crimps take place at the same time. One is the electrical connection between the conductor and terminal. The other is the insulation crimp which provides strain relief against vibration and tension. It is important that the electrical connection is gas-tight without any voids between the wire strands and the terminal. If there any voids present, then corrosion can occur causing resistance and excessive heat which damages the electrical connection. Using a good quality crimping tool will ensure that a full, gas-tight crimp is produced preventing future deterioration of the electrical connection and insulation breakage.