- RS-stocknr.:
- 321-161
- Fabrikantnummer:
- GHG4118201R1308
- Fabrikant:
- Eaton
5 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
49 op voorraad - levertijd is 3 à 5 werkdagen (UK-voorraad)
Toegevoegd
Prijs Per stuk
€ 270,56
(excl. BTW)
€ 327,38
(incl. BTW)
Aantal stuks | Per stuk |
1 + | € 270,56 |
- RS-stocknr.:
- 321-161
- Fabrikantnummer:
- GHG4118201R1308
- Fabrikant:
- Eaton
Wetgeving en conformiteit
N.v.t.
- Land van herkomst:
- DE
Productomschrijving
Dual Pushbutton
Start and Stop pushbuttons
Depth: 90mm
Depth: 90mm
Certificate No.
PTB 00 ATEX 3117
Group and Category
II 2 G EEx e d IIC T6
Eaton CEAG Start Stop Control Station - Crouse-Hinds Series - GHG4118201R1308
Looking for a control station to provide reliable circuit protection? This CEAG push-button unit from Eaton's Crouse-Hinds series effectively manages power and offers durability. Hard-wearing thermoplastic housing provides excellent insulation and makes the controller highly resistant to impact and chemicals. Its IP67 (ingress protection) rating also ensures it's completely dust-tight and water-resistant, while explosion protection means the unit is safe for use in hazardous commercial and industrial environments.
The stop and start push buttons snap in and out quickly for easy wiring. This product is ideal for off-shore applications and circuit-control tasks in demanding mechanical and chemical conditions.
The stop and start push buttons snap in and out quickly for easy wiring. This product is ideal for off-shore applications and circuit-control tasks in demanding mechanical and chemical conditions.
• Low side walls for optimal cable connection
• M20 bottom cable entry with cable gland for ease of installation
• Notches in the mounting rails to stop built-in components from twisting out of place
• M20 bottom cable entry with cable gland for ease of installation
• Notches in the mounting rails to stop built-in components from twisting out of place
What is an explosion-protected product?
Explosion protection indicates that the control station is Zone 1 and 2 ATEX (atmosphere explosible) certified. This means it's universally approved for use in areas where explosive gases are likely to be present during normal operation.
Where can I mount this control station?
This unit is suitable for wall mounting. It's supplied with fixing holes that are easily accessible without the need to break the seal on the enclosure cover.
Note
CEAG Hazardous Area
Suitable for use in Zone 1 hazardous areas
Impact resistant thermoplastic
Ingress protection to IP67 (unless stated otherwise)
Impact resistant thermoplastic
Ingress protection to IP67 (unless stated otherwise)
Rated voltage: contact blocks; 500V, signal lamps; 240V
Rated current: contact blocks; 16A
M20 bottom cable entry complete with cable-gland
Rated current: contact blocks; 16A
M20 bottom cable entry complete with cable-gland
Specificaties
Kenmerk | Waarde |
---|---|
Series | CROUSE-HINDS |
Number of Cutouts | 2 |
Enclosure Colour | Black |
IP Rating | IP65, IP67 |
Cutout Diameter | 22mm |
Length | 125mm |
Width | 85mm |
Hazardous Area Certification | ATEX |
Depth | 77.5mm |
Maximum Operating Temperature | +40°C |
Minimum Operating Temperature | -20°C |
Maximum DC Voltage | 110V |
Maximum AC Voltage | 500V |
Maximum Current | 16A |