Redundancy module for use with Y Series

  • RS-stocknr. 627-6253
  • Fabrikantnummer YR2.DIODE
  • Fabrikant PULS
Datasheets
Wetgeving en conformiteit
Conform
Land van herkomst: CZ
Productomschrijving

YR2.DIODE DC12-48 V, 20 A, Dual Redundancy Module

Dual diode redundancy module for building 1+1 and N +1 redundant power supply systems. It has two input channels which can be connected to 10 A power supplies and one output which can carry nominal currents up to 20 A. The YR2.DIODE is an excellent choice for use in a redundant system if the power supply is equipped with a DC-OK signal.

Features and Benefits

• Two 10 A inputs, one output (20A max.)
• Only 0.85 V voltage drop between input and output under full load
• Full output current between -40 °C and 60°C
• Quick connect spring-clamp terminals
• Reverse polarity protected input
• DC 12 V to 48 V, 20A output
• DC 12 V dc to 48 V dc (±25%) input
• Size: 32 x 124 x 102 mm (W x H x D)
• Weight 290 g

Product Application Information

A possible application for the diode is to use it to isolate sensitive load circuits with or without alarm signals. This avoids distortion of the power quality which can cause controller failures.

Standards

IEC, UL, EN, SELV

Specificaties
Kenmerk Waarde
Accessory Type Redundancy Module
For Use With Y Series
19 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
50 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
57,51
(excl. BTW)
69,59
(incl. BTW)
Aantal stuks
Per stuk
1 +
57,51 €
Related Products
Combining a SITOP power supply and a 90° ...
Description:
Combining a SITOP power supply and a 90° mounting bracket results in a minimum surface area requirement on the rear panel of the control cabinet. The width of the power supply becomes the depth, and the depth becomes the width. ...
The RSPxxx-168 is a surge protector module designed ...
Description:
The RSPxxx-168 is a surge protector module designed to protect DC/DC converters from railway over-voltage transients up to 385VDC. The output voltage tracks the input voltage in the range of 40-165VDC, thereafter the output voltage is clamped to 168VDC. The ...
Buffering with service free electrolytic capacitors24V or 48V ...
Description:
Buffering with service free electrolytic capacitors24V or 48V models availableConstant output voltage in buffer modeBuffer time 0.2s at 20A (24V) or 0.1s at 20A (48V)Longer hold-up time at lower levelsBuffer units can be connected in parallel to increase the output ...
The din rail mounting, Trio Diode redundancy modules ...
Description:
The din rail mounting, Trio Diode redundancy modules from Phoenix contact are designed to isolate parallel-switched PSU’s. Using the redundancy module prevents short circuits affecting the load by checking the wiring from the power supply to the diode.Using the redundancy ...