Development Kit DHB Module for use with DRV8833 Dual H-Bridge Motor Driver

  • RS-stocknr. 184-0471
  • Fabrikantnummer 410-259
  • Fabrikant Digilent
Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

The Pmod DHB1 uses the Texas Instruments® DRV8833 dual H-Bridge motor driver chip to drive two DC motors or a single stepper motor. Each H-Bridge can be driven by GPIO signals.

Dual H-Bridge capable of 1.5A RMS
Two quadrature encoder channels for motor feedback
Two JST 6-pin ports for connection to Digilent motor/gearbox
Over-current protection
Recommended 10.8 V max motor voltage
Logic input voltage range of 2.5 V to 5 V
Small PCB size for flexible designs 1.3“ ´ 1.8” (3.3 cm ´ 4.6 cm)
Follows Digilent Pmod Interface Specification Type 5

Specificaties
Kenmerk Waarde
Power Management Function Half-Bridge Driver
Kit Name PmodDHB1 Module
1 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
14,34
(excl. BTW)
17,35
(incl. BTW)
Aantal stuks
Per stuk
1 +
14,34 €
Related Products
The HIP2103_4MBEVAL1Z mother board with the HIP2103DBEVAL1Z and ...
Description:
The HIP2103_4MBEVAL1Z mother board with the HIP2103DBEVAL1Z and HIP2104DBEVAL1Z evaluation daughter cards constitute an evaluation tool for the HIP2103 and HIP2104 half bridge MOSFET drivers.The motherboard platform provides an on-board microcontroller that is used to generate appropriate control inputs to ...
xChips are a rapid electronics development ecosystem to ...
Description:
xChips are a rapid electronics development ecosystem to help reduce development time and simplify making custom products as well as aiding learning. Without soldering, wiring, breadboarding, or hardware knowledge you can assemble a circuit in minutes, and concentrate on coding.xChips ...
Position Sensorless BLDC Drivers (no Hall Sensor required)180° ...
Description:
Position Sensorless BLDC Drivers (no Hall Sensor required)180° Sinusoidal Drive for High Efficiency and Low Acoustic NoiseSupports 2V to 14V Power SuppliesSpeed Control through Power Supply Modulation (PSM) and/or Pulse-Width Modulation (PWM)Built-In Frequency Generator (FG output signal)Built-In Lock-Up ...
Supports up to 20V Output Pull-up Voltage–40°C to ...
Description:
Supports up to 20V Output Pull-up Voltage–40°C to 125°C Operating Temperature RangeSupports Wide Range of Stepper Motors, DC Motors, Relays, and Inductive CoilsLow Output VOL of 0.4V (Typical) With– 140mA Current Sink per Channel at 5.0V Logic Input(1)– 1A Current ...