Microchip MCP25612FD-E/SL, CAN Transceiver 8MBps 2-Channel CAN 2.0, CAN FD, 14-Pin SOIC

  • RS-stocknr. 893-8102
  • Fabrikantnummer MCP25612FD-E/SL
  • Fabrikant Microchip
Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

MCP25612FD CAN Transceivers

From Microchip the MCP25612FD is a dual CAN Transceiver that supports both CAN 2.0 (Classic) and CAN FD (Flexible Data-rate) physical layer requirements, allowing designers to build flexibility into their CAN based applications. This IC offers the features of two fully independent MCP2561FD CAN Transceivers (except the SPLIT pin) on one chip, making this device optimal for applications where CAN network redundancy is a critical consideration.

Features

Supports both CAN 2.0 and CAN FD physical layer requirements
Optimized for CAN FD (Flexible Data-Rate) at 2, 5 and 8 Mbps Operation
Maximum Propagation Delay: 120 ns
Loop Delay Symmetry: -10%/+10% (2 Mbps)
Two Fully Independent VDDX and VSSX Pins per CAN FD Transceiver
Standby Current: 5 μA per transceiver (typical)

CAN Bus Communication - Microchip

Specificaties
Kenmerk Waarde
Maximum Data Rate 8Mbps
Number of Transceivers 2
Standard Supported CAN 2.0, CAN FD
Power Down Mode Standby
Maximum Supply Current 70 mA
Mounting Type Surface Mount
Package Type SOIC
Pin Count 14
Dimensions 8.65 x 3.9 x 1.25mm
Length 8.65mm
Width 3.9mm
Height 1.25mm
Maximum Operating Supply Voltage 5.5 V
Maximum Operating Temperature +125 °C
Minimum Operating Temperature -40 °C
Minimum Operating Supply Voltage 4.5 V
170 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 10)
0,96
(excl. BTW)
1,16
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
10 - 20
0,96 €
9,60 €
30 - 90
0,908 €
9,08 €
100 +
0,828 €
8,28 €
*prijsindicatie
Related Products
Controller Area Network (CAN or CAN-bus) is a ...
Description:
Controller Area Network (CAN or CAN-bus) is a computer network protocol and bus standard designed to allow microcontrollers and devices to communicate with each other without a host computer. It was designed specifically for automotive applications but is now also ...
Infineon’s CAN (Control Area Network) transceivers are designed ...
Description:
Infineon’s CAN (Control Area Network) transceivers are designed for use in the automotive industry. The data rate can go up to 1Mbps and they have different features including receive only mode, INH output as well as Bus wake up inputs. ...
Controller Area Network (CAN or CAN-bus) is a ...
Description:
Controller Area Network (CAN or CAN-bus) is a computer network protocol and bus standard designed to allow microcontrollers and devices to communicate with each other without a host computer. It was designed specifically for automotive applications but is now also ...
LIN is a small, serial, slow, and cheap ...
Description:
LIN is a small, serial, slow, and cheap bus system. LIN is based on one master node and a number of LIN slaves (up to 16). It is a low-cost concept for automobile networks, for which it standardizes the transmission ...