Ultimaker Isolator for use with Ultimaker 2

  • RS-stocknr. 908-2944
  • Fabrikantnummer 1310
  • Fabrikant Ultimaker
Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: NL
Productomschrijving

Hot End Isolator for Ultimaker 2

The Hot End Isolator connects the PTFE coupler, nozzle and heater block

Note

Only compatible with the Ultimaker 2 Family

Ultimaker Accessories

Specificaties
Kenmerk Waarde
Product Type Isolator
For Use With Ultimaker 2
12 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
45,54
(excl. BTW)
55,10
(incl. BTW)
Aantal stuks
Per stuk
1 +
45,54 €
Related Products
The Olsson block brass Jet nozzles have a ...
Description:
The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip ...
The Olsson block Stainless Steel Jet nozzle has ...
Description:
The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them ...
Heating block for precise filament extruding complete with ...
Description:
Heating block for precise filament extruding complete with nozzle. It is recommended for use with all materials from Z-Filament Series. Replace Hot-End V1 with this new version and achieve better printing results. • Replacement part compatible with the Zortrax M200 ...
BQ original Classic Hot-end HeatCore equipped with thermal ...
Description:
BQ original Classic Hot-end HeatCore equipped with thermal connector and a 100k NTC resistor. MK7 Nozzle Diameter 0.4 mm, compatible for 1.75 filamentThermobarrier including Teflon inlay (tube)Fast connecting 12 V 40W ceramic heater cartridge with connectorFast connecting 100K thermistor (NTC) ...