Ultimaker Nozzle for use with Olsson Block 0.25mm

  • RS-stocknr. 110-1982
  • Fabrikantnummer OBN001
  • Fabrikant Ultimaker
Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: NL
Productomschrijving

Ultimaker 2 Jet Nozzles

The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip more. You can print 3°C to 5°C lower because of this treatment, and is also useful for oozing and drips.

With these special nozzles, you can print faster, the plastic flows much more easier than in classic nozzles. You can also clean them efficiently with cold pulls (or atomic pulls). The geometry of the inside makes it easier to get rid of plastic so changing colours or filament type is done faster and safer.

Use the 0.25mm brass nozzle to print small detailed prints, it's an expert nozzle (RS 110-1982)
The 0.4mm (RS 110-1983) is the standard size for a lot of 3D printers
If you print in wood filaments, this brass nozzle of 0.8mm is perfect for the job (RS 110-1985)

Note

This nozzle is compatible with M6 Threads, you can put it on the Ultimaker Original (the fan shroud must be modified) or any of the Ultimaker family that has the Olsson Block mounted.

Ultimaker Accessories

Specificaties
Kenmerk Waarde
Product Type Nozzle
For Use With Olsson Block
Nozzle Material Brass
Nozzle Size 0.25mm
4 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
15 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
34,75
(excl. BTW)
42,05
(incl. BTW)
Aantal stuks
Per stuk
1 +
34,75 €
Related Products
Heating block for precise filament extruding complete with ...
Description:
Heating block for precise filament extruding complete with nozzle. It is recommended for use with all materials from Z-Filament Series. Replace Hot-End V1 with this new version and achieve better printing results. • Replacement part compatible with the Zortrax M200 ...
The Ultimaker print core range will be offered ...
Description:
The Ultimaker print core range will be offered in type AA. It gives extra-fine detail prints, with the added advantage of dual extrusion - enabling two-colour prints, or various material combinations with extra-fine detail. Different nozzle sizes can be quickly ...
The Ultimaker Professional 3D printing just got more ...
Description:
The Ultimaker Professional 3D printing just got more accessible. Maximize the print performance and machine uptime with our swappable, material-matching print cores. Make the most out of reliable build and support material combinations for geometric freedom or print in dual ...
Print without interruption with a handy set of ...
Description:
Print without interruption with a handy set of five 0.6 mm nozzles for the Ultimaker 2+ series. Simple to replace, they help you achieve a good level of detail at a higher speed.