FTDI Chip FT601Q-B-T, USB Bridge IC, USB 2.0, USB 3.0 2-Port at 480 (USB 2.0) Mbit/s, 5 (USB 3.0) Gbit/s, 3.3 V dc,

  • RS-stocknr. 146-6840
  • Fabrikantnummer FT601Q-B-T
  • Fabrikant FTDI Chip
Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

Enabling faster and higher volume data transfers than ever before, the FT600 and FT601 Super Speed USB3.0 ICs offer USB access to a wider range of data intensive imaging and data acquisition applications. The series incorporates two vendor class USB devices supported by our D3xx driver. The FT600 and FT601 function as Super Speed USB3.0 to FIFO bridges, providing up to 5Gbps of bandwidth. devices - the FT600 and FT601, which function as Super Speed USB3.0 to FIFO bridges, providing up to 5Gbps of bandwidth.

16bit/32bit wide parallel FIFO interface.
Supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 400MBps.
Supports multi channel FIFO interface.
Up to 8 configurable endpoints (pipes).
Built-in 16kB FIFO data buffer RAM.
Supports multi voltage I/O: 1.8V, 2.5V and 3.3V.
Configurable GPIO support.
Supports Remote Wakeup capability.
Provides USB Battery Charger Detection.
Integrated power-on-reset circuit.

Specificaties
Kenmerk Waarde
Number of Transceivers 2
Data Rate 5 (USB 3.0) Gbit/s, 480 (USB 2.0) Mbit/s
Protocols Supported USB 2.0, USB 3.0
Power Supply Type Single
ESD Protection Yes
Typical Single Supply Voltage 3.3 V dc
Mounting Type Surface Mount
Package Type QFN
Pin Count 76
Dimensions 9.1 x 9.1 x 0.95mm
Height 0.95mm
Length 9.1mm
Maximum Operating Temperature +85 °C
Width 9.1mm
Minimum Operating Temperature -40 °C
23 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
7,55
(excl. BTW)
9,14
(incl. BTW)
Aantal stuks
Per stuk
1 - 9
7,55 €
10 - 24
7,34 €
25 - 49
7,15 €
50 - 99
6,96 €
100 +
6,79 €
Verpakkingsopties
Related Products
The CSTCR series of MHz band ceramic resonators ...
Description:
The CSTCR series of MHz band ceramic resonators from Murata are part of the CERALOCK® range. CERALOCK® ceramic resonators are constructed from high stability piezoelectric ceramics. Featuring built in load capacitance, these SMD ceramic resonators eliminate the need for external ...
The FT245B and FT245R are USB to parallel ...
Description:
The FT245B and FT245R are USB to parallel FIFO converter interfaces. Single chip USB to parallel FIFO bidirectional data transfer interfaceEntire USB protocol handled on the chip - No USB-specific firmware programming requiredFT245B USB compatibleFT245R USB 2.0 Full Speed compatibleFT245R ...
The FTDI Chip FT232R is a USB to ...
Description:
The FTDI Chip FT232R is a USB to serial UART interface with optional clock generator output. Asynchronous and synchronous bit bang interface modes are also available. Together with EEPROM, clock circuit and USB resistors effectively makes it a "3 in ...
The FT245B and FT245R are USB to parallel ...
Description:
The FT245B and FT245R are USB to parallel FIFO converter interfaces. Single chip USB to parallel FIFO bidirectional data transfer interfaceEntire USB protocol handled on the chip - No USB-specific firmware programming requiredFT245B USB compatibleFT245R USB 2.0 Full Speed compatibleFT245R ...