FTDI Chip FT600Q-B-T, USB Bridge IC, USB 2.0, USB 3.0 2-Port at 480 (USB 2.0) Mbit/s, 5 (USB 3.0) Gbit/s, 3.3 V dc,

  • RS-stocknr. 146-6835
  • Fabrikantnummer FT600Q-B-T
  • Fabrikant FTDI Chip
Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

Enabling faster and higher volume data transfers than ever before, the FT600 and FT601 Super Speed USB3.0 ICs offer USB access to a wider range of data intensive imaging and data acquisition applications. The series incorporates two vendor class USB devices supported by our D3xx driver. The FT600 and FT601 function as Super Speed USB3.0 to FIFO bridges, providing up to 5Gbps of bandwidth. devices - the FT600 and FT601, which function as Super Speed USB3.0 to FIFO bridges, providing up to 5Gbps of bandwidth.

16bit/32bit wide parallel FIFO interface.
Supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 400MBps.
Supports multi channel FIFO interface.
Up to 8 configurable endpoints (pipes).
Built-in 16kB FIFO data buffer RAM.
Supports multi voltage I/O: 1.8V, 2.5V and 3.3V.
Configurable GPIO support.
Supports Remote Wakeup capability.
Provides USB Battery Charger Detection.
Integrated power-on-reset circuit.

Specificaties
Kenmerk Waarde
Number of Transceivers 2
Data Rate 5 (USB 3.0) Gbit/s, 480 (USB 2.0) Mbit/s
Protocols Supported USB 2.0, USB 3.0
Power Supply Type Single
ESD Protection Yes
Typical Single Supply Voltage 3.3 V dc
Mounting Type Surface Mount
Package Type QFN
Pin Count 56
Dimensions 7.1 x 7.1 x 0.69mm
Height 0.69mm
Length 7.1mm
Maximum Operating Temperature +85 °C
Minimum Operating Temperature -40 °C
Width 7.1mm
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 17/02/2021, met een levertijd van 2 à 3 werkdagen.
Prijs Each (In a Tray of 260)
6,17
(excl. BTW)
7,47
(incl. BTW)
Aantal stuks
Per stuk
Per tray*
260 +
6,17 €
1.604,20 €
*prijsindicatie
Related Products
Designed to replace an existing DE9 connector, (male ...
Description:
Designed to replace an existing DE9 connector, (male or female) RS-232/TTL UART connection with a drop-in USB replacement connection. Miniaturised modules which closely resemble a DE9 connector for PCB mountingUSB mini-B socket connectorThe modules contain a USB-Serial bridge IC and ...
The TTL-232R-Rpi from FTDI is a USB to ...
Description:
The TTL-232R-Rpi from FTDI is a USB to TTL level serial UART converter cable designed for use with a Raspberry Pi. Upon inspection, there is a USB connector with USB 2.0 full speed compatibility and 3 single pole 0.1m pitch ...
The FTDI Chip FT232R is a USB to ...
Description:
The FTDI Chip FT232R is a USB to serial UART interface with optional clock generator output. Asynchronous and synchronous bit bang interface modes are also available. Together with EEPROM, clock circuit and USB resistors effectively makes it a "3 in ...
The FT220X and FT221X Full Speed USB 2.0 ...
Description:
The FT220X and FT221X Full Speed USB 2.0 ICs offer a compact bridge to 4-Bit SPI / FT1248 interfaces. The devices can acknowledge USB bus data, capable of operating up to 500 kbps, with low power consumption (8 mA). The ...