RSCAL(1770518)GO NO-GO PLUG GAUGE M18

  • RS-stocknr. 189-3330
  • Fabrikantnummer 16029 +Cal
  • Fabrikant Volkel
Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: DE
Productomschrijving

A thread limit plug gauge is a combination of go plug gauge and no-go plug gauge. The scrap side of the thread plug gauge is marked with a red ring. The go end of the thread plug gauge must screw into the thread cut into a part by hand (without using excessive force). If unable to do so, the thread does not meet the requested standards (=scrap). The scrap side of the thread plug gauge must not be able to be manually turned more than two turns into the cut thread (without using excessive force). If it can be screwed in more, the thread does not meet the requested standards (=scrap). The reference temperature for parts and gauges is 20° Celsius. Calibrated at a measurement laboratory separate from VÖLKEL. Calibrated using IAC thread scanners.

Specificaties
Kenmerk Waarde
Plug/Ring Plug
Gauge Type Go/No Go
Thread Size M18 x 2.5
Pitch Diameter 2.5mm
Tolerance 6H
Single or Double Ended Double
Imperial or Metric Metric
Calibrated RSCAL
tijdelijk niet op voorraad – nieuwe voorraad verwacht op 16/11/2020, met een levertijd van 2 à 3 werkdagen.
Prijs Each
126,38
(excl. BTW)
152,92
(incl. BTW)
Aantal stuks
Per stuk
1 +
126,38 €
Related Products
The Volkel Go No-Go plug gauge M18x2.5 is ...
Description:
The Volkel Go No-Go plug gauge M18x2.5 is calibrated at measurement laboratory using IAC thread scanners. The scrap side of this thread plug gauge is marked with a red ring. This gauge must screw into the part by hand more ...
The GO thread ring gauge must be possible ...
Description:
The GO thread ring gauge must be possible to manually screw into the entire thread of the part (without using excessive force). If unable to do so, the thread does not meet the requested standards (=scrap). The reference temperature for ...
The thread NO-GO ring gauge must not screw ...
Description:
The thread NO-GO ring gauge must not screw into the part by hand more than two threads (without using excessive force). If the ring gauge can be screwed into the thread by more than two threads, the thread does not ...