Burkert Solenoid Valve 93970143, 2 port , NC, 24 V dc, 3/4in

  • RS-stocknr. 816-3269
  • Fabrikantnummer 93970143
  • Fabrikant Burkert
Datasheets
Wetgeving en conformiteit
Conform
Land van herkomst: DE
Productomschrijving

DS6281-EV 2/2 Solenoid Valve - Stainless Steel

A 2 way servo assisted solenoid valves suitable for use with neutral fluids such as compressed air and water. N/C (Normally Closed) and N/O (Normally Open) versions available with NBR (Nitrile Rubber) or FKM (Fluroelastomer) seals. Usable for a variety of applications including heating and refrigeration, water treatment, compressed air and vacuum systems
ATEX approved versions available.

0.1 - 4 second response time (dependant upon pressure)
IP65 Rated (with cable protection)
Stainless steel body
Quiet operation
Water hammer free design
Compact installation length
NPT / Rc connection ports
0.2 - 16 Bar pressure range

Compact solenoid valves suitable for most gas and fluid handling applications. Where practical, valves are shown with a schematic diagram showing the (circuit) function. The diagram is laid out so that the left-hand side of the diagram describes the valves operation when the coil is energised. When the coil is de-energised, the spring (or servo-assist) return controls the valve and is described on the right-hand side of the diagram. The 3 / 2-way designation indicates a valve with three ports and two modes of operation. It is normal practice to refer to 2 / 2-way valves as two ways. The port designations A, B, P, P1, P2 and R are used on the schematic diagrams and are marked on the valve bodies. Valve bodies are marked for a specific circuit function but can often be used for other functions. Reference to the schematic diagrams and technical specifications indicates the appropriate connections and pressure capabilities when an alternative circuit function is required.

Specificaties
Kenmerk Waarde
Supply Voltage 24 V dc
Number of Ports 2
Operation Pilot
Connection 3/4 in G
Connection Size 3/4in
Default Valve Position NC
Suitable Applications Hot Air, Pre-Solution
Type 2/2
Orifice Diameter 20mm
Body Material Stainless Steel
Maximum Working Pressure 16 bar
Operating Temperature Range 0 → +120 °C
Minimum Operating Temperature 0°C
Maximum Operating Temperature +120°C
Series 6281 EV Standard
Maximum Closing Time 0.1 → 4s
Connection Gender Female
Thread Standard or Connection Type G
Servo Assist Yes
Flow Factor Kv 8.5m³/h
3 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
247,67
(excl. BTW)
299,68
(incl. BTW)
Aantal stuks
Per stuk
1 +
247,67 €
Related Products
Solenoid valves with pivoted armatures. Lockable manual over-ride3-pin ...
Description:
Solenoid valves with pivoted armatures. Lockable manual over-ride3-pin DIN connector rated to IP65 can be positioned through 360° in 90° incrementsDuty cycle intermittent operation 40% 30 min8W nominal coil powerPower consumption 30VA (in-rush), 15 VA/8W (hold) a.c, A 8W d.c.Zero ...
Two-way, stainless steel solenoid valves with zero bar ...
Description:
Two-way, stainless steel solenoid valves with zero bar minimum operating pressure, normally closed, threaded port connection. Stainless steel bodyPressure not required for operation Compact & lightweightDIN plug connectionRanging from -25 to +85°C Can be mounted in any position.
Two-way, pilot operated solenoid valves, minimum operating pressure ...
Description:
Two-way, pilot operated solenoid valves, minimum operating pressure required, normally closed with threaded port connection. Brass bodyMinimum operating pressure requiredCompact & lightweightDIN plug connection Ranging from -20 to +85°CCan be mounted in any position.
Two-way, brass-bodied WRAS listed solenoid valves with anti-water ...
Description:
Two-way, brass-bodied WRAS listed solenoid valves with anti-water hammer devices fitted as standard. They have a zero bar minimum operating pressure and are normally closed. The compact, lightweight unit may be mounted in any position (however, for optimum life, certain ...