TE Connectivity Transparent Solder Sleeve 1.6 → 3.2mm

Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: MX
Productomschrijving

CWT15 wire terminals

These terminals allow connection of wires to component pins, posts, tabs or terminals.
Compatible with numerous dielectric and insulating materials, even those that are heat-sensitive.
The solder connections are insulated, protected and highly resistant to mechanical stress due to the combined use of a fluxed solder ring and a heatshrink sleeve.
Quick and easy-to-use: simply place the terminal and the wire together and heat them using a hot air gun.
The clear sleeve facilitates connection quality control.

//media.rs-online.com/t_line/LF180823-10.gif
Specificaties
Kenmerk Waarde
Minimum Cable Diameter 1.6mm
Maximum Cable Diameter 3.2mm
Sleeve Length 16mm
Material Polyolefin
Minimum Operating Temperature -55°C
Maximum Operating Temperature +125°C
Colour Transparent
100 op voorraad - levertijd is 1 werkdag(en)
Prijs Each (In a Pack of 10)
0,56
(excl. BTW)
0,68
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
10 - 140
0,56 €
5,60 €
150 - 490
0,535 €
5,35 €
500 +
0,505 €
5,05 €
*prijsindicatie
Related Products
These sealed sleeves enable several wires to be ...
Description:
These sealed sleeves enable several wires to be soldered together, for applications where a high degree of reliability is essential.Recommended for locations that would be difficult to access later.They feature a heat-fusion adhesive insert to ensure the splice is sealed.Easy ...
The Solder Sleeve introduction kit contains various solder ...
Description:
The Solder Sleeve introduction kit contains various solder sleeves suitable for terminating a wide range of cable and wire constructions from 0.9mm to 15.1mm. Solder Sleeves provide insulated, environmentally sealed; strain-relieved soldered connectionsTemperature range -55°C to +125°CTerminate bare or tin ...
A one piece soldering system for jointing signal ...
Description:
A one piece soldering system for jointing signal cables and terminating cable screens. The system consists of heat shrinkable sleeve containing a predetermined amount of fluxed solder and a thermoplastic sealing insert at each end. The solder sleeve is placed ...
Each terminator consists of heatshrinkable sleeve containing prefluxed ...
Description:
Each terminator consists of heatshrinkable sleeve containing prefluxed solder preform. To install, simply position the terminator over the pre-stripped wire/pin and apply heat. The sleeve will shrink and the solder will melt and flow, resulting in a perfectly soldered, insulated ...