Entrelec, SNA Series , 380 V ac Standard Din Rail Terminal, Screw Termination

  • RS-stocknr. 454-700
  • Fabrikantnummer 1SNA115542R1200
  • Fabrikant Entrelec
Datasheets
Wetgeving en conformiteit
Conform
Land van herkomst: FR
Productomschrijving

Triple Deck and Sensor

For the termination of 3 wire sensors. Common connection of the supply rails may be achieved with pre-assembled jumper bars allowing the remaining termination to be used for the sensor signal lead. Non-indicating and indicating versions are available for both PNP and NPN sensors. Cable size and current rating is 2.5mm² and 26 A for all types, with a mounting pitch of 6mm. Suitable for mounting on symmetric rail only (BS5584:1978),Sub-type A : 3 level feedthrough - use where space saving is a requisite.,Sub-type B : 2 single contacts and a feedthrough, ideally suited for power distribution across a number of sensors using jumper bars, enabling the top feedthrough connection to be used for the signal lead.Sub-type C : a three tier sensor terminal with red indication LED. Using the lower two terminations for power distribution, the upper feedthrough being used for the signal lead connection. The LED indicating sensor output suited to 24Vdc PNP output sensors.Sub-type D : a three tier terminal, similar to the type 3, but suited to a 24Vdc NPN output sensor.Sub-type E : a feedthrough terminal block with a green LED indicator to signify power on status. Suited to indicate signal/power conditions on PLCs. 24Vdc on LED circuit.

Note

Not all types may be available

//media.rs-online.com/t_line/L454693-05.gif
//media.rs-online.com/t_line/LE454693-02.gif

Approvals

7777

5000 Universal Series

This universal range of terminals mounts on both asymmetric rail 'G' profile and Top hat profile. Moulded in tough flame-resistant polyamide 6.6, with a working temperature of -55°C to +130°C. The captive terminal screws have hardened heads to prevent burring. Cable entry and clamp design allows easy installation, higher voltage and cable carrying capacity. Cable markers are available RS 460-569

Note

Stock numbers 472-9569 and 472-9575 are compatible with deep top hat rails only

Specificaties
Kenmerk Waarde
Series SNA
Cable CSA 2.5mm²
Colour Grey
Current Rating 22A
Number of Levels Triple
Termination Method Screw
Voltage Rating 380 V ac
Pitch 6mm
Minimum Operating Temperature -5°C
Maximum Operating Temperature +40°C
710 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 5)
2,544
(excl. BTW)
3,078
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
5 +
2,544 €
12,72 €
*prijsindicatie
Related Products
This universal range of terminals mounts on both ...
Description:
This universal range of terminals mounts on both asymmetric rail 'G' profile and Top hat profile. Moulded in tough flame-resistant polyamide 6.6, with a working temperature of -55°C to +130°C. The captive terminal screws have hardened heads to prevent burring. ...
Universal terminals moulded in polyamide to fit both ...
Description:
Universal terminals moulded in polyamide to fit both 'G' and 'Top Hat' rail.Screw conductor securing with closed screwdriver shafts. Available conductor acceptance sizes, 2.5mm² to 35mm². The range comprises of grey (phase), blue (neutral), and yellow/green (earth) terminals. A 10-way ...
Universal terminals moulded in polyamide to fit both ...
Description:
Universal terminals moulded in polyamide to fit both 'G' and 'Top Hat' rail.Screw conductor securing with closed screwdriver shafts. Available conductor acceptance sizes, 2.5mm² to 35mm². The range comprises of grey (phase), blue (neutral), and yellow/green (earth) terminals. A 10-way ...
Disconnect terminal blocks enable you to rapidly localise ...
Description:
Disconnect terminal blocks enable you to rapidly localise system faults, and permits inspection work to be carried out under zero voltage conditions. A standard height version for 2.5mm² wire, and a double-deck version for 4.0mm² wire is availableColour grey.