A1101EUA-T Allegro Microsystems, Unipolar Hall Effect Sensor Switch, 3-Pin Ultra Mini SIP

Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

A1101/2/3/4/6 Hall Effect Sensor Switch, Allegro Microsystems

The Allegro A1101/2/3/4 and A1106 Hall-effect switches are produced with BiCMOS technology enabling fast power-on time and low-noise operation. Device programming is performed after packaging, to ensure increased switch-point accuracy by eliminating offsets that could be induced by package stress.

Unique Hall element geometries and low offset amplifiers minimise noise and to reduce the residual offset voltage normally caused by device over-molding and thermal stress.

The Allegro A1101/2/3/4 and A1106 a voltage regulator, Hall voltage generator, small-signal amplifier, Schmitt trigger, and NMOS output transistor.

The integrated voltage regulator permits operation from 3.8 V to 24 V and on-board protection circuitry provides a ±30 V absolute maximum voltage rating. All devices in the family are identical except for magnetic switchpoint levels.

Continuous-time operation with fast power-on time and low noise
Stable operation over full operating temperature range
Reverse battery protection
Solid-state reliability
Factory-programmed at end of line for optimum performance
Robust EMC performance
High ESD rating
Regulator stability without a bypass capacitor

Hall Effect Sensors, Allegro MicroSystems

Specificaties
Kenmerk Waarde
Magnetic Type Unipolar
Mounting Type Through Hole
Pin Count 3
Minimum Magnetic Sensor Release Point 10 Gs
Maximum Magnetic Sensor Operating Point 160 Gs
Minimum Operating Supply Voltage 3.8 V
Maximum Operating Supply Voltage 24 V
Length 4.09mm
Width 1.52mm
Height 3.02mm
Dimensions 4.09 x 1.52 x 3.02mm
Minimum Operating Temperature -40 °C
Maximum Operating Temperature +85 °C
Package Type Ultra Mini SIP
Typical Magnetic Sensor Hysteresis 55 Gs
205 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
1010 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each (In a Pack of 5)
1,726
(excl. BTW)
2,088
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
5 - 20
1,726 €
8,63 €
25 - 95
1,21 €
6,05 €
100 - 245
0,95 €
4,75 €
250 - 495
0,876 €
4,38 €
500 +
0,80 €
4,00 €
*prijsindicatie
Verpakkingsopties
Related Products
The ATS468 is a true zero-speed gear tooth ...
Description:
The ATS468 is a true zero-speed gear tooth sensor IC consisting of an optimized Hall IC and a permanent magnet pellet configuration in a single overmolded package. The integrated circuit provides a manufacturer-friendly solution for digital gear tooth sensing applications. ...
The A1225/7/9 High Temperature Hall Effect Latches are ...
Description:
The A1225/7/9 High Temperature Hall Effect Latches are temperature-stable and stress resistant suitable for operation for temperatures up to 150°C. A Schmitt trigger circuit maintains operate and release point symmetry by compensating for temperature changes in the Hall element. Internal ...
The A3211/2 are ultrasensitive, pole independent, Hall-effect switches ...
Description:
The A3211/2 are ultrasensitive, pole independent, Hall-effect switches with latched digital output. Their 2.5 V to 3.5 V operation and unique clocking scheme reduces the average operating power to less than 15 μW with a 2.75 V supply.Either a north ...
3D magnetic flux density sensing of ±160mTProgrammable flux ...
Description:
3D magnetic flux density sensing of ±160mTProgrammable flux resolution down to 65μT (typ.)X-Y angular measurement modePower down mode with 7nA (typ) power consumption12bit data resolution for each measurement direction plus 10bit temperature sensorVariable update frequencies and power modes (configurable during ...