Microchip 10 bit Energy Meter IC 28-Pin QFN, MCP39F511N-E/MQ

  • RS-stocknr. 111-5576
  • Fabrikantnummer MCP39F511N-E/MQ
  • Fabrikant Microchip
Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

MCP39F511N Energy Measurement ICs

The MCP39F511N from Microchip is an integrated, dual-channel, single-phase power monitoring device that provides real-time measurement of input power and energy values for AC/DC power supplies. The capabilities of the MCP39F511N are ideal for applications such as dual-socket wall outlets, power strips, AC/DC power supplies, and power distribution.

On-board are three Analogue-to-Digital Converters (ADCs) for voltage and current load measurement, a 16-bit Calculation Engine, EEPROM and a flexible 2-Wire Interface. An integrated low-drift voltage reference combined with the 94.5 dB of SINAD performance on each measurement channel allows for better than 0.5% accurate designs across a 4000:1 dynamic range.

Features

Power monitoring of two loads
Power monitoring accuracy capable of 0.5% error across 4000:1 dynamic range
Built-in calculations using a 16-Bit processing core measuring:
- Active, reactive and apparent Power
- Active and reactive energy accumulation
- True RMS current, RMS voltage
- Line frequency, power factor
Dedicated Zero Crossing Detection (ZCD) pin
Dedicated PWM output pin
Automatic event pin control through fast voltage surge detection
Fast calibration routines
2-wire UART with 115.2k baud rate
512 bytes user-accessible EEPROM through page read/write commands
Non-volatile on-chip Memory
Low-Drift Internal Voltage Reference: 10 ppm/°C typical
Extended Temperature Range -40°C to +125°C

Energy/Power Measurement - Microchip

Specificaties
Kenmerk Waarde
Resolution 10 bit
Mounting Type Surface Mount
Package Type QFN
Pin Count 28
Dimensions 5 x 5 x 0.8mm
Length 5mm
Width 5mm
Height 0.8mm
Maximum Operating Supply Voltage 3.6 V
Maximum Operating Temperature +125 °C
Minimum Operating Supply Voltage 2.7 V
Minimum Operating Temperature -40 °C
65 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 5)
2,132
(excl. BTW)
2,58
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
5 - 20
2,132 €
10,66 €
25 - 95
2,066 €
10,33 €
100 +
1,994 €
9,97 €
*prijsindicatie
Verpakkingsopties
Related Products
ACM3P series 3-phase AC ammeters measure and display ...
Description:
ACM3P series 3-phase AC ammeters measure and display the true-RMS values of 2- or 3-phase ac mains current. A front panel touch switch enables the selection of a continuous reading of any of the three phases. All ACM3P ammeters are ...
The ND10 is a digital programmable power meter ...
Description:
The ND10 is a digital programmable power meter designed to measure 3 phase, 4-wire power network parameters in both balanced and unbalanced systems. It displays measured quantities and their simultaneous digital transmission. The power meter also controls and optimises the ...
The MEMO4 is an energy meter dedicated to ...
Description:
The MEMO4 is an energy meter dedicated to measuring and rebilling energy consumption on a 230 V ac single phase network. The meter allows you to check the main quantities at a glance on its backlit LCD screen due to ...
Using CMS-700 it is possible to measure and ...
Description:
Using CMS-700 it is possible to measure and calculate electrical parameters from both the mains and the branches, in order to provide the most comprehensive set of information on the system.A maximum of 3x32 sensors can be connected to the ...