0110N Safety Edge Profile, Protected Area 1m, SET Wire Lead

Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: GB
Productomschrijving

Safedge Profiles

The Safedge pressure sensitive system is supplied in two popular profiles, with cushion factor over travel distances of 5mm and 19mm. The cushion factor is the distance the profile can be depressed after a signal has been generated.
It is mounted on an aluminium C rail (included) and is supplied in 1, 1.5 and 2m lengths that may be cut and joined in series or parallel to support a wide range of industrial applications such as power operated doors, guided vehicles and moving machinery beds.
The Safedge profile uses a combination of non-conductive rubber and flexible wire cored conductive rubber bonded together enabling it to return to its original shape even after repeated compressions.
It has no rigid internal parts to damage the rubber profile or cause fatigue failures after prolonged use. The multi-stranded copper wire core throughout the length of the strip also insures that there are no problems of resistance build up on long lengths.
A range of accessories for end termination and 90° active corner joints are also available.

2 different profile designs
Conductive rubber technology
Available in 1m, 1.5m or 2m lengths
Aluminium mounting rail
The system has a bend radius of 200mm
Rubber boot optional
Active corners
IP65 protection

Note

These Safedge profiles are supplied part assembled. The series terminating resistor and associated end closing cap are not attached to the profile but are supplied separately in a bag. This allows the profile to be cut to the appropriate length before completing the assembly by inserting the resistor and gluing the end cap in place using industrial cyanoacrylate adhesive.

//media.rs-online.com/t_line/L249600-01.gif

Allen Bradley Guardmaster Safety Edge Profile

The Mobrey vibrating rod level switch is the perfect solution for single-point level switching in free-flowing solids across a wide density range, from fine powders to grains. A single rod design provides the solution to tuning forks which may become blocked or bridged. The vibration rod is energized and kept in resonance by an electronic circuit. When covered by material, the damping of the vibration is detected by the electronics which initiate the switching of the output relay after a built-in programmable time delay.

Supplied with:
User manual, 2 – 3-pole terminal blocks, 1in sealing, 2 – Pg 16 cable glands.

How do you carry out an installation?
Requiring only a 1in BSP/NPT socket, either on the top or in the sidewall of the silo, the unit is easy to install and simple to the commission.
Prior to installation, it is advised to check the switching function for proper adjustment on a sample quantity of material. The unit may not work with mediums within specified density range but having a very large size of granules or extremely little friction.

WARNING!
Handle device with great care, especially the sensing probe. Any impact on the sensing probe can ruin its resonance system.
A protective shield should be installed if the probe is exposed to falling material or an excessive mechanical load.

Features and Benefits

• The system has a bend radius of 200mm
• Rubber boot optional
• Active corners

Applications

• Power-operated doors
• Guided vehicles
• Moving machinery beds

Certifications

• IP65 protection

Safety Edge

Specificaties
Kenmerk Waarde
Protected Area 1m
Range Safedge
Length 24.5mm
Series 440-F
Width 28.5mm
Profile 0110N
Terminal Type SET Wire Lead
IP Rating IP67
Material EPDM, NBR/CR
2 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
20 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
246,00
(excl. BTW)
297,66
(incl. BTW)
Aantal stuks
Per stuk
1 +
246,00 €
Related Products
The Allen Bradley GuardMaster control unit is the ...
Description:
The Allen Bradley GuardMaster control unit is the newest tech accessory for use with pressure-sensitive safety edge system. It is made of polycarbonate and has 22.5mm DIN RAIL mounting. The Bulletin 440F Safedge™ controllers operate with bulletin 440F Safedge safety ...
Our Bulletin 440F Safedge™ Safety Edge Profiles come ...
Description:
Our Bulletin 440F Safedge™ Safety Edge Profiles come in three different cushion factors and two different materials. They have no rigid internal parts that can break through or cause fatigue failures after prolonged use. Various profiles availableConductive rubber technologyUp to ...
Aluminium type, Type C112/A. Suitable for all profiles. ...
Description:
Aluminium type, Type C112/A. Suitable for all profiles.
The Kobra Hygiecam series from IDEM are tongue ...
Description:
The Kobra Hygiecam series from IDEM are tongue operated safety interlock switches that fit to the leading edge of sliding, hinged or lift off machine guards. These safety switches have positively operated switching contacts and a strong tamper resistant key ...