Entrelec, CPP Cover for Terminal Block

  • RS-stocknr. 225-4473
  • Fabrikantnummer 1SNA163418R2600
  • Fabrikant Entrelec
Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: FR
Productomschrijving

High Current Double Stud Terminals and Shrouds

A set of 4 spacers is available and should be fitted between each terminal to provide additional isolation. A translucent cover which snaps onto the spacers and can span 3 adjacent terminals is also available as a set.

2 shunt-connect studs and 4 terminals up to 300mm2
Ideal for power cable termination
EExe and EExi certification for use in hazardous areas

5000 Universal Series

This universal range of terminals mounts on both asymmetric rail 'G' profile and Top hat profile. Moulded in tough flame-resistant polyamide 6.6, with a working temperature of -55°C to +130°C. The captive terminal screws have hardened heads to prevent burring. Cable entry and clamp design allows easy installation, higher voltage and cable carrying capacity. Cable markers are available RS 460-569

Note

Stock numbers 472-9569 and 472-9575 are compatible with deep top hat rails only

Specificaties
Kenmerk Waarde
Accessory Type Cover
Series CPP
For Use With Terminal Block
103 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
3,84
(excl. BTW)
4,65
(incl. BTW)
Aantal stuks
Per stuk
1 +
3,84 €
Related Products
For the termination of 3 wire sensors. Common ...
Description:
For the termination of 3 wire sensors. Common connection of the supply rails may be achieved with pre-assembled jumper bars allowing the remaining termination to be used for the sensor signal lead. Non-indicating and indicating versions are available for both ...
DIN rail mounting component boxes with screw terminal ...
Description:
DIN rail mounting component boxes with screw terminal connections. A matrix type PCB is available, for each size box, with connections to all terminals. Typical applications include: PCB relays and associated circuitry, opto-isolators and other signal interfacing. The Standard size ...
DIN rails and brackets are made from cold ...
Description:
DIN rails and brackets are made from cold rolled steel that is zinc coated and passivated. The coating thickness is a minimum of 8 microns. All DIN Rail meets current BS, DIN, AND CENELEC Standards,A steel, snap-on mounting bracket with ...
Requires a separator end section every 40cm approx ...
Description:
Requires a separator end section every 40cm approx and at DIN rail extremities. A 6mm dia hole is required in the cover at each separator. Transparent PVC protective cover, 1m length in 2 sizesSnap-fits into place and secured with a ...