Development Kit Tester Click for use with Testing and Diagnostics of the MikroBUS™ Socket Pin States

Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

Tester click is a Click board™ used as a diagnostic tool on the mikroBUS™ socket. It contains an array of 2x6 LEDs, which signalize the presence of the HIGH/LOW logic level on each pin, providing a visual feedback to the developer. Two additional LEDs indicate the presence of +3.3V and +5V on the mikroBUS™ power rails. This simple diagnostic tool can save hours of troubleshooting, saving the application developer from having to connect various complicated measurement instruments, only to test logic states on the specific mikroBUS™ pins.

Specificaties
Kenmerk Waarde
Accessory Type Tester Click
For Use With Testing and Diagnostics of the MikroBUS™ Socket Pin States
3 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
5,90
(excl. BTW)
7,14
(incl. BTW)
Aantal stuks
Per stuk
1 +
5,90 €
Related Products
Compatible Design Upgrade 3D Printers Printers, POS Office ...
Description:
Compatible Design Upgrade 3D Printers Printers, POS Office and home automation Textile, Sewing Machines CCTV, Security ATM, Cash recycler HVAC2-phase stepper motors up to 2A coil current (peak) STEP/DIR Interface with 2, 4, 8, 16 or 32 microstep pin setting ...
1024-position resolution Nonvolatile memory maintains wiper setting Power-on ...
Description:
1024-position resolution Nonvolatile memory maintains wiper setting Power-on refresh with EEMEM setting EEMEM restore time: 140 μs typ Full monotonic operation 10 kΩ, 50 kΩ, and 100 kΩ terminal resistance Permanent memory write protection Wiper setting readback Predefined linear increment/decrement ...
Fully integrated 3-axis magnetic sensor and electronic circuits ...
Description:
Fully integrated 3-axis magnetic sensor and electronic circuits requiring fewer external components Superior Dynamic Range and Accuracy: ±16 G FSR with 16/14 bits operation 0.5 mG/2 mG per LSB resolution in 16/14 bits operation mode 1.5 mG total RMS noise ...
No firmware development requiredSimple GUI-based configuratorIntegrated USB transceiver, ...
Description:
No firmware development requiredSimple GUI-based configuratorIntegrated USB transceiver, no external resistors requiredIntegrated clock, no external crystal requiredUSB 2.0 full-speed compatibleData transfer rates up to 3 MbaudUSB Battery Charger Detection (USB BCS 1.2 Specification)Remote wakeup for waking a ...