Development Kit PWM for use with Adjustable System Clock Generator

Datasheets
Wetgeving en conformiteit
Conform
Productomschrijving

PLL click is a frequency multiplier which uses the Phase-Locked Loop (PLL) techniques to provide a high-frequency clock output from a cheap, standard fundamental mode crystal oscillator. In addition to this, PLL click also offers a choice between nine different multiplication factors, programmed via states of the two input pins. The output range of the PLL click goes up to 160MHz

Packaged as 8-pin SOIC, MSOP, or die
IDT’s lowest cost PLL clock
Zero ppm multiplication error
Input crystal frequency of 5 - 27 MHz
Input clock frequency of 2 - 50 MHz
Output clock frequencies up to 160 MHz
Extremely low jitter of 25 ps (one sigma)
Compatible with all popular CPUs
Duty cycle of 45/55 up to 160 MHz
Nine selectable frequencies
Operating voltage of 3.3 V or 5.0 V
Tri-state output for board level testing
25 mA drive capability at TTL levels
Ideal for oscillator replacement
Industrial temperature version available
Advanced, low-power CMOS process

Specificaties
Kenmerk Waarde
Accessory Type PWM
For Use With Adjustable System Clock Generator
9 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
14,70
(excl. BTW)
17,79
(incl. BTW)
Aantal stuks
Per stuk
1 +
14,70 €
Related Products
The SigFox click is a device which carries ...
Description:
The SigFox click is a device which carries the SN10-11, a fully integrated module by InnoComm, allowing connection to a low power wide area network (LPWAN) that enables communication utilizing the Industrial, Scientific, and Medical (ISM) radio frequency band. The ...
Low Input Offset Voltage: 250 μV (maximum)Rail-to-Rail OutputLow ...
Description:
Low Input Offset Voltage: 250 μV (maximum)Rail-to-Rail OutputLow Input Bias Current: 80 pA (maximum at +85°C)Low Quiescent Current: 25 μA (maximum)Power Supply Voltage: 2.5V to 6.0VUnity-Gain StableChip Select (CS) Capability: MCP608Industrial Temperature Range: -40°C to +85°CNo Phase ReversalAvailable in Single, ...
Position Sensorless BLDC Drivers (no Hall Sensor required)180° ...
Description:
Position Sensorless BLDC Drivers (no Hall Sensor required)180° Sinusoidal Drive for High Efficiency and Low Acoustic NoiseSupports 2V to 14V Power SuppliesSpeed Control through Power Supply Modulation (PSM) and/or Pulse-Width Modulation (PWM)Built-In Frequency Generator (FG output signal)Built-In Lock-Up ...
Can Be Read in Less Than 5msOperating Range: ...
Description:
Can Be Read in Less Than 5msOperating Range: 2.8V to 6.0V, -40°C to +85°CUnique Factory-Lasered 64-Bit Registration Number Ensures Error-Free Device Selection and Absolute Traceability Because No Two Parts are AlikeBuilt-In Multidrop Controller for 1-Wire NetDigital Identification by Momentary ContactData ...