Parker, DC Motor Controller, 1 Phase, Voltage Control, 110 → 500 V, 32 A, Wall Mount

  • RS-stocknr. 240-6731
  • Fabrikantnummer 514C-32-00-00-00
  • Fabrikant Parker
Wetgeving en conformiteit
Land van herkomst: GB

514C Range (Regenerative) Speed Controllers

The 514C range of isolated dc motor speed controllers provide fully regenerative (four quadrant) control of dc shunt and permanent magnet motors. They are particularly suitable for overhauling load applications or where accurately controlled braking is required.

Fully regenerative, four-quadrant motor control
Internal logic control of power supply ac contactor
Ramped speed input, auxiliary and inverted auxiliary inputs

Features of 512C and 514C Range Speed Controllers

Jumper-selectable single phase input voltage 110//120 or 220//240 or 380/415V ±10%
Linear current feedback allowing accurate torque
Zero speed or zero set point relay driver output - 24Vdc
Total setpoint output
Stall detection and trip
Field bridge suitable for UK or continental voltages
Overload capacity 150% of nominal current for 60s
Adjustable maximum current level
Adjustable maximum and minimum speed

Adjustable I.R. compensation (for armature voltage feedback speed control)
Adjustable speed stability
Independent control of speed ramp, both up and down from 0-40s
Indication of mains supply on, stall trip and overcurrent trip
Switch selectable current calibration
Switch selectable Armature/Tacho generator feedback
Buffered 0-10V output for a speed reference or meter
Buffered 0-7.5V output for a current meter (7.5V = 150%)

Supplied with

a comprehensive instruction manual.

Kenmerk Waarde
Supply Voltage 110 → 500 V
Current Rating 32 A
Voltage Rating 360 V dc
Compatible Motor Type Permanent Magnet, Shunt
Control Input Voltage
Mounting Style Wall Mount
Phase 1
Length 240mm
Width 160mm
Depth 130mm
Dimensions 240 x 160 x 130 mm
Operating Temperature Range 0 → +40 °C
5 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
(excl. BTW)
(incl. BTW)
Aantal stuks
Per stuk
1 +
928,19 €
Related Products
This range of cost effective low voltage dc. ...
This range of cost effective low voltage dc. motor controllers are suitable for use with permanent magnet dc. motors up to 12A. The boxed version is protected to IP22.,Comprehensive instruction sheet supplied. Adjustable maximum and minimum speedsIR compensationAdjustable overloadFused input ...
The ADS50 is a powerful servo amplifier for ...
The ADS50 is a powerful servo amplifier for the control of brushed permanent magnet dc. motors. Four operating modes can be selected by DIP switches on the amplifierSpeed control using tacho, encoder or IR compensation or torque (current) control are ...
Suitable for permanent magnet and wound field dc ...
Suitable for permanent magnet and wound field dc motorsSupply 12 or 24Vdc battery or linear power supplyContinuous rating 24A, maximum current limited to less than 36AAdjustable electronic current limit up to 36ASpeed control by potentiometerSoft startHeatsink thermally protectedRunning/Fault/Trip ...
Cost-effective dc motor speed controllers suitable for use ...
Cost-effective dc motor speed controllers suitable for use with shunt and permanent dc motors, such as the Parvalux range. The built-in EMC and Harmonic Filters can enable a complete drive to conform with the statutory EMC and Harmonics directives. High ...