ETA Busbar, 5 Module, 24V dc, 59.5mm Pitch

  • RS-stocknr. 723-4875
  • Fabrikantnummer X222.611.59 BUSBAR (PACK OF 10)
  • Fabrikant ETA
Datasheets
Wetgeving en conformiteit
Conform
Land van herkomst: DE
Productomschrijving

ESX10-T Electronic Circuit Protectors

Electronic circuit protector type ESX10-T is designed to ensure selective disconnection of DC24V load systems. By active current limitation, ESX10-T responds much faster to overload or short circuit conditions than switch-mode power supply. The ESX10-T limits the highest possible current to 1.3 to 1.8 times the selected rated current of the circuit protector. It is therefore possible to switch on capacitive loads of up to 20,000μF, but they are disconnected only in the event of an overload or short circuit.

Selective load protection, electronic trip characteristics
Reliable overload disconnection with 1.1 x lN plus, even with long load lines or small cable cross sections
Manual ON/OFF button (S1)
Status and failure indication through LED, status output SF or Si contact F
Integral fail-safe element adjusted to current rating
Can be snapped onto symmetrical rails for ease of installation and space-saving in control cabinets
Ease of wiring through busbar LINE+ and 0 V as well as signal bars and bridges

Approvals

UL, CSA

Approvals

UL, CSA

Specificaties
Kenmerk Waarde
Rated Operational Voltage 24V dc
Number Of Modules 5
Pitch 59.5mm
20 op voorraad - levertijd is 1 werkdag(en).
Prijs Each (In a Pack of 10)
7,461
(excl. BTW)
9,028
(incl. BTW)
Aantal stuks
Per stuk
Per pak*
10 - 40
7,461 €
74,61 €
50 +
7,157 €
71,57 €
*prijsindicatie
Related Products
The inner life of the KOPP MCB has ...
Description:
The inner life of the KOPP MCB has changed significantly compared with previous automatic cut-out technology. The thermal actuator consists of a bimetal snap disc that is integrated into the magnetic actuator. This has reduced the number of welded connections ...
Busbars for safe and rational connection of distributor ...
Description:
Busbars for safe and rational connection of distributor installation devices, e.g. automatic cut-outs (MCB)1 and 3-phase versions availableNo end caps supplied with cut-to-length busbars, please order separately.
The bus terminal is used for connecting the ...
Description:
The bus terminal is used for connecting the bus line to EIB devices such as flush-mounted bus couplers, couplers and 4-fold connectors as well as for looping or branching of the bus cableWhen connecting the bus cable, the correct polarity ...
Range of cutable comb busbars compatible with IC60, ...
Description:
Range of cutable comb busbars compatible with IC60, IID, ISW-NA, IK60, IID K and ISW switch disconnector. Mounting mode: Horizontal Rated operational voltage: 415 V AC Rated insulation voltage: 500 V AC.