CEL Single Material Dual Nozzle Head for use with all models of Robox 3D Printer

  • RS-stocknr. 903-1325
  • Fabrikantnummer RBX01-S2
  • Fabrikant CEL
Datasheets
Wetgeving en conformiteit
Conform
Land van herkomst: CN
Productomschrijving

CEL 3D Printing Parts & Accessoriess

The CEL single material dual nozzle head for Robox 3D printer has 2 nozzles both of which are supplied from a single material feed. Silicone heater jackets prevent stray material from sticking to the hot parts of the nozzle and heater block. They also insulate and prevent drafts at the hot end to allow faster heating with less energy.The nozzle head is fitted to Robox via the headlock and system uses needle valves to close the nozzles to avoid stringing and blob.NoteRBX1 Robox is required to use this kit. Robox is not included and is sold separately. Some simple assembly is required

Features and Benefits

Detailed high-resolution prints using the smaller 0.3mm nozzle Fast fill and small details in the same layer of the print Improved heatsink with more cooling fins and more efficient thermodynamic performance Material Compatibility: PLA, ABS, HIPS, Nylon, PC, PVA Modified head housing for improved connection reliability with the x-carriage. New needle seal design for improved reliability and life. Quick draft prints using the 0.8mm nozzle Silicone Thermal Jacket - Improves heat-up time Titanium Heat Bridge - Fully all-metal construction means the head can cope with higher temperatures (>280°C)

Robox Accessories

Specificaties
Kenmerk Waarde
Product Type Single Material Dual Nozzle Head
For Use With All models of Robox 3D Printer
6 op voorraad - levertijd is 1 werkdag(en).
Prijs Each
146,32
(excl. BTW)
177,05
(incl. BTW)
Aantal stuks
Per stuk
1 +
146,32 €
Related Products
The Olsson block brass Jet nozzles have a ...
Description:
The Olsson block brass Jet nozzles have a special tip angle and shoulder width, they also have a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them slip ...
The Olsson block Stainless Steel Jet nozzle has ...
Description:
The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them ...
Heating block for precise filament extruding complete with ...
Description:
Heating block for precise filament extruding complete with nozzle. It is recommended for use with all materials from Z-Filament Series. Replace Hot-End V1 with this new version and achieve better printing results. • Replacement part compatible with the Zortrax M200 ...
The 1.75 mm plastic extruder from Zmorph is ...
Description:
The 1.75 mm plastic extruder from Zmorph is a basic solution for single material 3D printing. The extruder is made from aluminium and stainless steel, while brass filament drives (toothed pulley) ensure the filament is gripped securely and doesn’t slip. ...