Ultimaker Olsson Block Kit for use with 2 Extended, 2 Extended+, 2+, Ultimaker 2

  • RS-stocknr. 110-1981
  • Fabrikantnummer OBK001
  • Fabrikant Ultimaker
Datasheets
Wetgeving en conformiteit
N.v.t.
Land van herkomst: NL
Productomschrijving

Ultimaker 3D Olsson Block Printing Parts & Accessoriess

The Ultimaker allows for quick and easy nozzle changes, so different nozzle sizes can be selected to suit each project. A larger nozzle is suitable for faster printing, while a smaller nozzle can be used to create more detailed prints.Note:Use of a torque wrench with the socket is not required but highly recommended to install nozzles without over-tightening. If a torque wrench is available for use with the socket during installation, please set it to a force between 1 and 1.5Nm. Take care not to set the force higher than 2Nm, as the nozzle could break off inside the block.Supplied with:Olsson block comes with 4 nozzles in various sizes (0.25mm, 0.40mm, 0.60mm and 0.80mm), a screwdriver and a socket.

Features and Benefits

Filaments are available in different sizes and diameters and nozzles always need to be carefully selected Nozzles or dual nozzles are in constant operation and its wearing risk is increased

Applications

Heated beds Motor extruders

Ultimaker Accessories

Specificaties
Kenmerk Waarde
Product Type Olsson Block Kit
For Use With Ultimaker 2, 2 Extended, 2 Extended+, 2+
3 op voorraad - levertijd is 1 werkdag(en) (EU-voorraad)
16 op voorraad - levertijd is 1 werkdag(en) (UK-voorraad)
Prijs Each
129,99
(excl. BTW)
157,29
(incl. BTW)
Aantal stuks
Per stuk
1 +
129,99 €
Related Products
The Olsson block Stainless Steel Jet nozzle has ...
Description:
The Olsson block Stainless Steel Jet nozzle has a special tip angle and shoulder width, it also has a special internal geometry with an angle less steep down to the nozzle hole. A special treatment applied inside also makes them ...
BQ original Classic Hot-end HeatCore equipped with thermal ...
Description:
BQ original Classic Hot-end HeatCore equipped with thermal connector and a 100k NTC resistor. MK7 Nozzle Diameter 0.4 mm, compatible for 1.75 filamentThermobarrier including Teflon inlay (tube)Fast connecting 12 V 40W ceramic heater cartridge with connectorFast connecting 100K thermistor (NTC) ...
The CEL single material dual nozzle head for ...
Description:
The CEL single material dual nozzle head for Robox 3D printer has 2 nozzles both of which are supplied from a single material feed. Silicone heater jackets prevent stray material from sticking to the hot parts of the nozzle and ...
The Ultimaker glass plate is the printing platform ...
Description:
The Ultimaker glass plate is the printing platform of the Ultimaker 3. This sheet of safety glass provides a smooth and flat surface for printing and distributes the warmth from the heated bed below. The thin layer of glue to ...